2345彩票代理歡迎您的到來!

2345彩票代理(蘇州福盛泰物流設備有限公司東北辦事處)
您現在的位置:首頁>>門封,卸貨平台新聞 >> 「撫順工業門封」海綿式門封的技術參數及使用注意事項

    「撫順工業門封」海綿式門封的技術參數及使用注意事項

    作者:撫順工業門封   發布時間: 2019/8/19 9:03:45

  •  

    「撫順工業門封」海綿式門封的技術參數及使用注意事項


    Technical parameters and matters needing attention in the use of "Fushun Industrial Door Seal" sponge type door seals



    選擇擠壓式海綿門封的注意事項:封墊對牆壁産生的壓力約為每米120千克。


    Notes for choosing extruded sponge door seals: The pressure generated by the seals on the walls is about 120 kg per meter.


    斜角封墊約為一半。建築物牆壁到防撞膠平面至少要有10厘米的空隙,以為門封擠壓後的厚度留有餘地。


    The bevel gasket is about half. The wall of the building should have at least 10 centimeters of clearance from the collision-proof glue plane, leaving room for the thickness of the door seal after extrusion.

     

    撫順工業門封定做




    封墊的厚度應高出防撞膠平面10到20厘米,高出15厘米适合。裝卸區地面坡度大于2%時,應使用錐壯封墊。


    The thickness of the gasket should be 10 to 20 centimeters higher than the collision-proof glue plane and 15 centimeters higher. When the slope of the loading and unloading area is more than 2%, the conical sealing pad should be used.


    坡度每增加一個百分點,封墊頂部厚度比底部厚度應小2.5厘米。


    For every percentage point increase in slope, the top thickness of the gasket should be 2.5 cm less than the bottom thickness.


    海綿門封與機械門罩相比,擠壓式門封能封閉貨車與平台間的空隙,且成本較低,但另一方面,門封會令貨台門洞的寬度減少,有時會影響托闆流暢地進出貨車。


    Comparing with mechanical door cover, extrusion door seal can close the gap between truck and platform at a lower cost, but on the other hand, door seal can reduce the width of the door hole of the platform and sometimes affect the smooth access of pallets to and from the truck.


    比如在另一個情況下,貨車尾部有伸出的台闆時,門封的使用會受到影響。平台門寬于2.8米或高于3.0米時,不能使用門封。


    For example, in another case, the use of door seals will be affected when there is an extended platform at the rear of the truck. When the platform door is wider than 2.8 meters or higher than 3.0 meters, the door seal should not be used.


    (1) 海綿墊式門封:這種門封是靠車廂的擠壓達到封閉成效。它的封閉性較好,便要求廂式車型号統一。


    (1) Sponge cushion door seal: This kind of door seal is achieved by the extrusion of the carriage. Because of its good closure, the van type is required to be uniform.


    (2) 機械式門封:這種門封是靠彈性高門封簾對車廂的擠壓達到封閉成效,适合大型車輛使用。


    (2) Mechanical door seals: This kind of door seals is achieved by the extrusion of the carriage by the elastic high door curtain, which is suitable for the use of large vehicles.


    (3) 充氣式門封:這種門封是将貨口周圍的氣囊充氣包住車廂,達到封閉效果。它的封閉成效好, 常用在食品、等潔淨度高的裝卸口,适合大中型車使用。


    (3) Inflatable door seal: This kind of door seal encloses the carriage by inflating the air bag around the cargo port to achieve the sealing effect. It has good sealing effect and is often used in food and other high cleanliness loading and unloading ports. It is suitable for large and medium-sized vehicles.


    門封可有效降低裝卸貨時的能量損失,阻隔風雨天氣、昆蟲、粉塵污染等與倉庫車輛内的貨物接觸。


    The door seal can effectively reduce the energy loss during loading and unloading, and prevent the weather, insects and dust pollution from contacting the goods in the warehouse vehicles.


    海綿門封這種裝卸系統多被采用密封門,從目前來看,形成封閉式裝卸系統是保護環境和貨物的方法可調節高度的海綿門封讓您有好的工作狀态,下面「撫順工業門封」龍盛門業為大家詳解可調節高度的海綿門封讓您有好的工作狀态,下面我們就做出具體的分析。


    Sponge door seal, a kind of loading and unloading system, is mostly used as a sealed door. At present, forming a closed loading and unloading system is a way to protect the environment and goods. It can adjust the height of the sponge door seal so that you have a good working condition. The following "Fushun Industrial Door Seal" Longsheng Door Industry explains in detail the adjustable height of the sponge door seal for you to have a good job. For status, we will make a specific analysis below.

     

    撫順海綿式門封安裝




    「撫順工業門封」海綿式門封的技術參數及使用注意事項



    Technical parameters and matters needing attention in the use of "Fushun Industrial Door Seal" sponge type door seals



    1、可調節海綿門封寬9’11”(3023mm),離地高 15’(4572mm),進深8”(203mm)。(基于48”(1220mm)的月台高度);


    1. Adjustable sponge door seal width 9'11 (3023 mm), height 15'(4572 mm), depth 8 (203 mm). (platform height based on 48 (1220 mm);


    2、貨車的高度範圍從12’3”(3734mm)到14’6”(4420mm);


    2. The height range of the truck ranges from 12'3 (3734 mm) to 14'6 (4420 mm).


    3、兩側削面型立柱在貨車與建築物牆體間形成良好密封;


    3. The two sides of the chamfered column form a good seal between the truck and the wall of the building.


    4、兩側立柱底部有透氣孔,兩側立柱安裝在經防腐處理的松木闆上;


    4. There are ventilation holes at the bottom of both sides of the column, and the two sides of the column are installed on the anticorrosion treated pine board.


    5、内部的高密度聚氨酯海綿牢固粘合在木闆上,織物包裹木闆,頂篷用高密度聚氨酯海綿填充;


    5. The high density polyurethane sponge inside is firmly bonded to the board, the fabric wraps the board, and the ceiling is filled with high density polyurethane sponge.


    6、門封配有36”(914mm)高的可調節頂部門簾,兩側立柱配備高24”(610mm),寬3.5”(90mm)的倒車指引條,頂篷的高密度聚氨酯海綿牢固粘合在木闆上,外表面由織物覆蓋,分離式頂部門簾由尼龍搭扣連接,頂部 門簾的兩端都安有層疊式耐磨褶皺


    6. The door seal is equipped with 36 (914mm) high adjustable top curtain. The two sides of the column are equipped with 24 (610mm) high and 3.5 (90mm) wide reversing guide strips. The high density polyurethane sponge of the ceiling is firmly bonded to the wooden board. The outer surface is covered by fabric. The separated top curtain is connected by nylon buckles. The two ends of the top curtain are provided with layers. Folded wear-resistant fold


    7、兩側立柱及頂部門簾織物選用22 oz黑色聚乙烯材質,頂部門簾上的耐磨褶皺選用22 oz黑色聚乙烯材質織物.


    7. The material of 22 oz black polyethylene is selected for the fabrics of the two sides pillars and the top curtain, and 22 oz black polyethylene is selected for the wear-resistant folds of the top curtain.
     

2345彩票代理
(蘇州福盛泰物流設備有限公司
東北辦事處)
電話:024-31081023
聯系人:于經理
網址:www.ilid.com.cn
版權所有:2345彩票代理
(蘇州福盛泰物流設備有限公司東北辦事處)
  
電話:024-31081023
聯系人:于經理
百度地圖 - 網站地圖 -